|
Post by shuttlespanker on Mar 22, 2023 7:47:22 GMT
Good morning all, in my thread regarding my Superdream non runner project, I have spoken about doing some powder coating on various parts Here is a short video showing the actual coating process Once the parts have been coated, the parts need to be baked at 180°c for 10 minutes, or until shiny all over, by whatever means necessary, an oven is best, but, as can be seen in the following pics, I used a gas heater and an electric heater on each side of the parts ![](https://i.ibb.co/wWq0237/IMG-20230321-WA0035.jpg) As with painting, the more preparation work put in before coating, the better the finish The parts in the video and picture are the seat release catches
|
|